Hot Runner Cable Testing - So Much Easier! Hot runner cable testing can be a tedious process. The traditional way of testing hot runner cables uses an ohmmeter or multimeter. The problem is that when cables are “set aside” in the “not-sure-what’s-wrong-with-it pile,” somebody has to troubleshoot the cables to see if they are faulty.
Hot Runner Maintenance - A Better & Safer Way! Hot runner maintenance can be a challenge. You look for dead shorts caused by pinched wires, open circuits, and you would want to measure the resistance of the heaters to ensure they are in a healthy range. Let’s start by measuring the resistance of the
Hot Runner Maintenance Using the MoldXChecker® Just like you would connect your hot half to a hot runner controller, you can now connect to the Fast Heat MoldXChecker®. If you’re wise and use the Mold Checker in the tool room, you would also know if you had an open heater. Waiting until you have a
Manny Diaz invented the Fast Heat CableXChecker® because of practical problems he experienced on service calls. It took too long and was too easy to make a mistake when checking for zone continuity and shorts (most people do not check for shorts) within hot runner cables. The CableXChecker® saves time (about 15 minutes per
PO Box 2874
Elkhart, IN 46515
Attn: Chad Root
574-606-4243
9951 W. 190th St. Suite M
Mokena, IL 60448
Attn: Manny Diaz
630-849-1779
© Copyright -2024 | Spark Industries
